PCB TOOLS / Electronics reference

GPIB/IEEE 48824-pin pinout

Look up GPIB eight-bit data, three-wire handshake, bus management, shield and logic returns.

Quick answer

1–4 and 13–16 carry DIO 1–8; 6DAV, 7 NRFD, 8 NDAC are handshake; 12 is shield and 24 logic ground.

Scope

Covers the common IEEE 48824-contact instrument interface; bus address is not contact number, and proper transceivers/controllers are required.The drawing does not define mechanical view.

Reading example

NRFD is 7 with paired return 19; 18–23 accompany DAV/NRFD/NDAC/IFC/SRQ/ATN respectively.

Legacy tables with visible corrections

GPIB24 contacts:data,handshake,management,shield versus logic ground
GPIB24 contacts:data,handshake,management,shield versus logic ground. Original functional list;not a verified mating/solder-side view,not to scale.
GPIB/IEEE 48824-pin pinout function allocation
PinNameDescription
1DIO1Data input/output bit 1
2DIO2Data input/output bit 2
3DIO3Data input/output bit 3
4DIO4Data input/output bit 4
5EOIEnd-or-identify
6DAVData valid
7NRFDNot ready for data
8NDACNot data accepted
9IFCInterface clear
10SRQService request
11ATNAttention
12SHIELDCable shield/chassis reference, not automatically PELegacy record: “Earth”. NI defines12 as Shield and 24 separately as Logic Ground; Earth overgeneralizes the source.
13DIO5Data input/output bit 5
14DIO6Data input/output bit 6
15DIO7Data input/output bit 7
16DIO8Data input/output bit 8
17RENRemote enable
18GND(wire twisted with DAV)
19GND(wire twisted with NRFD)
20GND(wire twisted with NDAC)
21GND(wire twisted with IFC)
22GND(wire twisted with SRQ)
23GND(wire twisted with ATN)
24Signal GNDGround
Legacy source notes and applicability

These notes retain the legacy record. For corrected facts and applicability, use this page’s quick answer, scope and visible table corrections.

Female GPIB/IEEE-488 connector

Frequently asked questions

Are SHIELD and Signal GND interchangeable?

Not from their names alone.12 and 24 have different roles; shield bonding follows the equipment EMC design.

Does device address5 mean contact 5?

No.Address is a protocol setting; contact 5 is EOI.

Related tools and references

Sources and verification

Legacy baseline: the Electrodoc Pro 5.2 data package. Raw records are retained and checked factual corrections are shown explicitly.