PCB TOOLS / Electronics reference

78xx Regulator Pins, Packages and Basic Circuits

Look up positive78xx regulator input, ground, output and fixed/lifted-ground circuits. Pin numbers use an explicit TI LM7805 TO-220 example; TO-3/TO-92/SO-8 cannot inherit the same layout.

Quick answer

Specified TI LM7805/LM7812/LM7815 three-lead TO-220 forms commonly use1 input,2 ground,3 output, with a grounded tab. This is not universal for78xx/78Lxx/negative regulators. Regulation still requires headroom, thermal design and the specified bypassing.

Scope

The source mixes packages/circuits without a complete ordering-code contract. Original diagrams therefore identify the verified model and functions. TO-3 can use its case as ground; TO-92/SO-8 need their own full manufacturer part numbers.79xx negative regulators use different connections. Capacitor requirements depend on device, distance and stability, not one universal example value.

Reading example

For12 V to5 V at0.2 A, dissipation excluding quiescent current is about(12−5)×0.2=1.4 W. A1 A/1.5 A label does not remove package/ambient thermal constraints.

Checked reference tables

Verified TI three-lead TO-220 example, not other packages
ContactFunction
1INPUT
2GND
3OUTPUT
TabGND for the specified models

Reference diagrams and checked notes

78XX pin-out

Specified78xx example and circuit: 78xx_pinout
Specified78xx example and circuit. Original functional diagram; model/revision/viewing and scope are explained in the page.

78XX Sample circuits

Specified78xx example and circuit: 78xx_circuit
Specified78xx example and circuit. Original functional diagram; model/revision/viewing and scope are explained in the page.
Legacy source notes and applicability

These notes retain the legacy record. For corrected facts and applicability, use this page’s quick answer, scope and visible table corrections.

78XX pin-out
78XX Sample circuits

Frequently asked questions

Do all78xx packages have the same pins?

No. Check the full part, package and top/bottom view before wiring; tabs/cases may be electrically connected.

How can heat be estimated first?

Start withP=(Vin−Vout)Iout, add quiescent loss and check junction temperature using thermal resistances and ambient conditions.

Related tools and references

Sources and verification

Legacy baseline: the Electrodoc Pro 5.2 data package. Raw records are retained and checked factual corrections are shown explicitly.